16
The product comes pre-paired, allowing immediate use upon
switching on the device without any additional steps. Pairing
becomes necessary only if a remote loses connection with
the master.
1 Ensure that both the Master and all Remote devices are powered on.
When the Master enters the pairing state, any Remotes not powered on will be
cleared from the set.
2 Make sure to mute off the microphone. (The LED indicator light will flash
slowly when mute is on, which may disrupt the pairing procedure.)
3 Simultaneously press the Volume Up and Down keys on the Master until
the Red LED indicator begins flashing quickly, indicating it has entered the
pairing state. Remote headsets share the same pairing activation steps by
simultaneously press volume up and down button. Start by pairing one Remote,
then proceed to pair the remaining lost Remotes one by one in sequence. The
newly connected Remotes can be powered on without any additional steps.
4 The Master will automatically exit the pairing state and the LED will become
solid once it is fully connected with all 4 Remotes. If there are fewer than
4 Remotes, you can manually exit the pairing state by pressing the Master
Headset power button. If you want to pair a Remote with a new Master, be sure
to turn off the previous Master that was paired with that Remote before initiating
the new pairing process.
KUMINIK8 Pairing Steps
CAME-KUMINIK8
Pairing Instructions
To Next Page
Loading...
Need help?
General
