CAME BPT MTMV/08 User Manual

1
2
M2 M3
PROG
<1’’
F
G
H
Page 4 - Manual FB00884-EN - vers. 1 - 09/2017- © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice.
Press the PROG button briefly H. The LEDs on the en-
try panel switch o.
Exiting Programming
On the entry panel, press the call
button to be linked to the internal
receiver G
1. A beep confirms
that the setting has been stored G
2. End the call and repeat for the
other internal receivers.
 The operation can only be carried out from the entry panel with the blue LED o (1 entry panel in F).
To change the entry panel from which calls are programmed, press one of the call buttons on the entry panel
you wish to use for programming.
 You can force the switch from one programming mode to another by pressing the PROG button on the
power supply unit for 3 seconds and releasing within 6 seconds. If you force the switch to call programming
from button programming, the button units which have not been programmed are configured to 8 calls. If the
base unit is not programmed, calls are not configured.
The green LED
flashes. Lift the internal receiver
handset (if present) and press the door lock release
and AUX2 buttons F.
Programming calls

CAME BPT MTMV/08 Specifications

General

Brand	CAME
Model	BPT MTMV/08
Category	Control Unit
Language	English