Canon LV-5210 User Manual

15
Part Names and Functions
To guarantee safe operation, please observe the following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture, or heat.
● Do not drop the remote control.
● If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Press the lid down-
ward and slide it.
Remove the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the compartment
lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
12 3
Point the remote control unit toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum
operating range for the remote control is about 16.4’ (5m) and 60° in front of the projector.
16.4’
(5 m)
60°
Remote Control Batteries Installation
Remote Control Operating Range

Canon LV-5210 Specifications

General

Resolution	800 x 600 pixels
Dimensions (WxDxH)	300 x 238 x 94 mm
Horizontal resolution	500 lines
Contrast ratio (typical)	400:1
Projector native resolution	SVGA (800x600)
Dot clock scanning frequency	100 MHz
Digital zoom	1.6 x
Lamp type	UHP
Lamp power	200 W
Light source type	Lamp
Number of built-in speakers	1
Power consumption (typical)	260 W

Weight and Dimensions

Weight	2900 g