17
KEYPAD FUNCTIONS - MODEL 210, Cont.
In addition to using the
ASTERISK
,
PRINT
key combination to change the print ticket
format, the operator (just prior to printing the ticket) can change the print ticket format at
the end of the weighing operation. This is accomplished by performing the normal
weighing operation, then pressing the desired format number (0, 1 or 2), followed by
pressing the
PRINT
key.
NOTE! When a print format is selected (by either method), it will remain active until
changed by the operator.
ANNUNCIATORS - MODEL 210
Annunciators are turned on to indicate that the display is in the mode corresponding to the
annunciator label or that the status indicated by the label is active. The annunciators flash on and
off to indicate that the 210 is waiting for an input from the keypad for the mode indicated by the
flashing annunciator.
ZERO
The ZERO annunciator is turned on to indicate that the weight is within +/- 1/4 division of the
center of zero.
STABLE
The STABLE annunciator is identified with two (2) small triangle shapes and is turned on when
the weight display is stable. This means that the change in successive weight samples is less than
the motion limits selected during setup and calibration of the instrument.
NET
The NET annunciator is turned on to show that the displayed weight is the net weight (gross
weight less tare weight).
GROSS
The GROSS annunciator is turned on to indicate that the displayed weight is the gross weight.
TARE
The TARE annunciator is turned on to show that the displayed weight is the tare weight.
LO BAT
The LO BAT annunciator is used with the battery operation and will turn ON to indicate that the
battery has less than one hour useful life before recharging will be required. If continued use
furthers drains the battery, no change in operation will occur until just before the battery voltage
drops to a level where operation is affected. At this level, the indicator will automatically turn itself
off. Refer to the Optional Battery Pack Operation section of this manual for more details.
UNDER/PWC1
The UNDER annunciator is used to signal that the displayed weight is less than the minimum value
of acceptable weight used in the Checkweigher feature. Note that this annunciator is active only
when the Checkweigher feature is enabled.
The PWC1 annunciator is turned on to indicate that the displayed weight is equal to or greater than
the weight value stored as preset number 1. Note that this annunciator is active only when the
Preset Weight Comparator feature has been enabled.
ACCEPT/PWC2
The ACCEPT annunciator is used to signal that the displayed weight is within the acceptable
weight limits for the Checkweigher feature. That is, it is equal to or greater than the minimum
acceptable weight and equal to or less than the maximum acceptable weight. Note that this
annunciator is active only when the Checkweigher feature has been enabled.
The PWC2 annunciator is turned on to indicate that the displayed weight is equal to or greater than
the weight value stored as preset number 2. Note that this annunciator is active only when the
Preset Weight Comparator feature has been enabled.
To Next Page
Loading...
Need help?
General
