40MBFAQ: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
12
SILENCE Mode
NOTE: The SILENCE Mode (SLC) is not available on this model.
LED Light
Press LED to turn the display light on and off.
Resetting the Remote Control
If the batteries in the remote control are removed, the current settings are
erased and the control returns to the initial settings and enters the
STANDBY mode. Push ON/OFF to activate.
Time Delay
If ON/OFF is pressed too soon after a stop, the compressor will not start
for 3 to 4 minutes due to the inherent protection against frequent
compressor cycling. The unit only emits an audible beep when the signals
are received correctly.
Heating Features
If the unit is in the HEATING mode, there is a delay when the fan starts.
The fan starts only after the coil is warmed up to prevent cold blow.
Auto Defrost Operation
In the HEATING mode, if the outdoor coil is frosted, the indoor fan and
outdoor fan turns off while the system removes the frost from the outdoor
coil. The system automatically reverts to normal operation when frost is
removed from the outdoor unit.
Auto Start
If the power fails while the unit is operating, the unit stores the
operating condition, and the unit will start operation automatically under
those conditions when the power is restored.
To Next Page
Loading...
Need help?
General
