Carrier 40MBFAQ User Manual

40MBFAQ: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
11
When Setting the Air Outlet Selection Switch to Single Air
Flow
Fig. 19 — Single Air Flow
• Regardless of the operating mode or situation, air blows from the
upper air outlet.
• Use this switch when you do not want air coming from the lower air
outlet; for example while sleeping.
NOTE: Lower air outlet only available on size 12.
Timer Function
TIMER ON (to start the unit) and TIMER OFF (to stop the unit) can be
used separately or together.
Timer ON Only
This function allows the unit to start automatically at the set time. The
TIMER ON function can be set while the unit is on or off.
Unit On
1. Press TIMER ON to initiate the auto-on time sequence. The set time is
displayed in the remote control display. Every time TIMER ON is
pressed, the time increases by 30 minutes, up to 10h. It increases by 60
minutes, afterwards, until the time setting reaches 24h.
2. When the TIMER ON is set, the TIMER light on unit illuminates.
The unit continues to run at the set time.
Unit Off
1. Set the timer described in the UNIT ON section. The unit starts at the
set time.
2. Adjust the TIMER ON settings to 0.0 to cancel this option.
Timer OFF Only
This function allows the unit to stop automatically at the set time. The
timer can be set while the unit is on or while it is off.
Unit On
Press TIMER OFF to initiate the auto-off time sequence. The set time
appears on the remote control display. Every time TIMER OFF is
pressed, the time increases by 30 minutes, up to 10h. It increases by 60
minutes, afterwards, until the time settings reach 24h.
When the TIMER OFF is set, the timer light on the unit illuminates and
the unit turns off automatically at the set time.
Unit Off
1. Set the TIMER OFF as described in the UNIT ON section. The
TIMER display on the unit illuminates and the unit remains off.
2. Adjust the TIMER ON settings to 0.0 to cancel this option.
Timer ON and Timer OFF
Use both functions to program the unit to turn on and shut off at specified
times.
Unit Off
1. Set TIMER ON as previously described.
2. Set TIMER OFF as previously described. The unit starts
automatically at the set TIME ON and turns off at the set TIME OFF.
Unit On
1. Set TIME OFF as previously described.
2. Set TIME ON as previously described. The unit turns off
automatically at the set TIME OFF and turns on at the set TIME ON.
SLEEP Mode
SLEEP mode is used to conserve energy. The mode can be used when the
unit is in the COOL, HEAT or AUTO mode only.
HEATING Mode
Same as the COOLING mode however the set points are lowered by 1.8°F
(1°C).
COOLING Mode
Push SLEEP. After 1 hour the set point raises by 1.8°F (1°C). After
another hour, the set point raises by another 1.8°F (1°C) and the fan runs
in a low speed. The unit shuts off 5 hours after setting the SLEEP mode.
SLEEP mode cancels if either MODE, TEMP, FAN, TIMER, or ON/
OFF on the remote control is pressed.
TURBO Mode
Use TURBO to cool or heat the room rapidly.
1. Press TURBO. An audible “beep” is heard if the indoor unit supports
this function. The fan runs on super high speed. The TURBO mode
terminates automatically 20 minutes after selecting TURBO.
2. To cancel TURBO, select TURBO mode again. When the TURBO
mode terminates, the unit reverts to the original setting.

Carrier 40MBFAQ Specifications

General

Brand	Carrier
Model	40MBFAQ
Category	Heater
Language	English