40MBFAQ: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
10
Selecting Right−Left Direction of the Louver
The right-left louvers can be adjusted manually to direct the airflow to
achieve optimal comfort in the space. A knob can be found on the right
side and the left side of the louvers.
Fig. 16 — Louver Right-Left (Size 12)
AIRFLOW SELECTION
1. Open the front panel.
2. Make the airflow selection that best suits you. When setting the air flow
selection, use the Dual Air Flow icon (see Fig. 17).
Fig. 17 — Dual Air Flow
NOTE: The air conditioner automatically determines the
appropriate blowing pattern based on the operating mode or
situation.
Table 1 — Operating Mode
Fig. 18 — Air Blows from Upper and Lower Outlets
Air is blown from the upper air outlet during the DRY mode, so cold air
does not come into direct contact with people.
Do not adjust the up−down airflow louver by hand. When
adjusting by hand, the mechanism may not operate properly or
condensation may drip from the air outlets.
CAUTION
OPERATING
MODE
COOL MODE HEAT MODE
Situation
When the room
totally cools, or
when one hour
has passed since
turning on the air
conditioner
At operation
start or other
times when
the room is
not totally
cooled.
At times
other than
below
(normal time)
At the start or
when the air
temp. is low.
Blowing Pattern
So air does not
come into direct
contact with
people, air is
blown from the
upper air outlet,
and the room
temp. is equalized.
Air is blown from the upper
and lower air outlets for high
speed cooling during the
COOL mode, and for filling
the room with warm air
during the HEAT mode (see
Fig. 18).
To keep air
from coming
into direct
contact with
occupants,
air blows
from the
upper air
outlet.
Before opening the front panel be sure to stop the operation and
turn the breaker OFF.
Do not touch the metal parts on the inside of the indoor unit, as it
may result in injury.
CAUTION
To Next Page
Loading...
Need help?
General
