To Next Page

To Previous Page

INTRODUCTION

Series 140/E 4--way multipoise Category I fan--assisted furnace is

CSA design--certified. A Category I fan--assisted furnace is an

appliance equipped with an integral mechanical means to either

draw or force products of combustion through the combustion

chamber and/or heat exchanger. The furnace is factory--shipped

for use with natural gas.

This furnace is not approved for installation in mobile homes,

recreational vehicles, or outdoors. This furnace is designed for

minimum continuous return--air temperature of 60_F(16_C) db

or intermittent operation down to 55_F(13_C)db such as when

used with a night setback thermostat. Return--air temperature

must not exceed 80_F(27_C) db. Failure to follow these

return--air temperature limits may affect reliability of heat

exchangers, motors, and controls. (See Fig. 3.)

For accessory installation details, refer to the applicable

instruction literature.

NOTE: Remove all shipping brackets and materials before

operating the furnace.

A10269

Fig. 2 -- Clearances to Combustibles

58DL

Carrier 58DLA User Manual

Other manuals for Carrier 58DLA