© 2020 Carrier. All rights reserved.
A Carrier Company
Edition Date: 09/20
Catalog No: 440 01 4521 01
Replaces: 441 01 4521 00B
F97CMN and G97CMN: Installation, Start-up, Operating and Service and Maintenance Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
78
PARTS REPLACEMENT INFORMATION GUIDE
Casing Group
Blower door
Bottom plate
Control door
Door knob assembly
Top filler plate
Electrical Group
3-Amp fuse
Circuit board
Control box
Door switch
Junction box
Limit switch(es)
Transformer
Blower Group
Blower housing
Blower motor
Blower wheel
Cut-off plate
Power choke (where used)
Filter Group
Filter(s)
Media Cabinet (when used)
Gas Control Group
Burner
Flame sensor
Gas valve
Hot surface igniter
Manifold
Orifice
Heat Exchanger Group
Containment plate
Coupling Box
Heat exchanger assembly
Primary HX cell panel
Secondary HX assembly
Tubing gaskets
Inducer Group
Collector box
Condensate trap
Condensate trap elbow
Gaskets
Inducer
Inducer assembly
Inducer motor capacitor (when used)
Inducer motor module (when used)
Pressure switch(es)
TO OBTAIN INFORMATION ON PARTS: Consult your installing dealer or classified section of your local telephone directory under “Heating
Equipment” or “Air Conditioning Contractors and Systems” headings for dealer listing by brand name or contact:
International Comfort Products
Consumer Relations Department
P.O. Box 128
Lewisburg, TN 37091, USA
931-270-4100
Have available the model number, series number, and serial number located on the unit rating plate to ensure correct replacement part.
Model Nomenclature
MODEL HEATING SIZE WIDTH
COOLING AIRFLOW
(CFM)
MINOR SERIES
(F/G)97CMN 060 17 14 --
FIRE, EXPLOSION, ELECTRICAL SHOCK AND CARBON MONOXIDE POISONING HAZARD
Failure to follow this warning could result in dangerous operation, personal injury, death or property damage.
Improper installation, adjustment, alteration, service, or maintenance can cause personal injury, property damage, or death. Consult a qualified
installer, service agency, or your local gas supplier for information or assistance. The qualified installer or service agency must use only
factory-authorized replacement parts, kits, or accessories when modifying this product.
WARNING
!
To Previous Page
Loading...
Need help?
General