2
INTRODUCTION
Carrier’s 7--day, 5/2--day, 1--day programmable and non--programmable
Performance Series Thermidistat Control is a wall--mounted, low--voltage control
which combines temperature and humidity control in either a single unit or a
two--piece unit. In two--piece configuration, the relays are located near the
equipment and a two--wire connection is used between the Display Module and the
Equipment Control Module. Single--piece installation requires more wiring and
results in a higher profile. The Edger Thermidistat has no need for batteries to store
user--configured settings in memory. During power loss its internal memory saves
settings for unlimited time, and the clock continues to run for at least 24 hours. An
extension of Carrier’s proven line of thermostats; it provides separate setpoints for
heating and cooling in addition to humidification and dehumidification.
In the Edge Thermidistat Control programmable configuration, different heating
and cooling setpoints and times are programmable for 4 periods per day or 2
periods per day. Programming can be done for 7 days per week, 5/2 days per week,
or 1 day. The programmable Thermidistat Control can also be user configured as a
non--programmable Thermidistat Control. When operating as non--programmable,
the Edge Thermidistat Control will still have both temperature and humidity
control.
The non--programmable Thermidistat Control features Touch ’N’ Got settings for
quick and easy temperature change without complicated programming schedules.
The non--programmable Edge Thermidistat Control will still have both temperature
and humidity control. And, its Touch ’N’ Go technology enables the user to switch
between three different user--configurable settings through intuitive buttons located
just below the display.
To Next Page
Loading...
Need help?
General
