Cascade C Series User Manual

22 8305557-R2
ADVANCED WEIGHING OPERATIONS
FK0773.eps
Piece Count (Sampling Method) (continued)
9 The indicator will show the sample load quantity, as
entered, and "pcs" icon.
NOTE: The indicator will show "–Lo_" briefly when APW
is too light and can not be sampled.
11 The indicator will show the quantity of the load.
12 Continue to acquire load quantities with the same
sample APW. To exit this mode, press the "UNITS"
button.
NOTE: The indicator does not retain APW after exiting
this mode or being turned off.
10 Remove the sample load and add a load to count on
the pallet (or into bin).
8 The indicator will show "5" (default value). To sample with
a different quantity, refer to the "Configuration Mode Button
Functions" (below) to change the quantity. To accept the
default or entered value, press "NET/GROSS" button.
7
8
9
10
11
12
7 The screen will show "AddPCS". Press "NET/GROSS" button.
NOTE: If "AddPCS" does not show, press the "ON/PRINT"
button until "AddPCS" shows.
Increase
Value
To change quantity:
Press to accept default quantity
Press to continue
Press only if "AddPCS"
does not show.
Quantity (default or entered)
To exit Piece
Count Mode
Load's
weight
shows
after
exiting
Decrease
Value
Accept
Value
Shift to the
next digit,
left
Shift to the
next digit,
right
Configuration Mode Button Functions

Cascade C Series Specifications

General

Brand	Cascade
Model	C Series
Category	Forklifts
Language	English