Part-1
9
E
QUICK START OPERATION
Part-1
1. Initialization / Loading Memory Protection Battery
Important
You must initialize
the Cash register.
◗ To initialize the cash register
1. Set the Mode Switch to OFF.
2. Plug the power cord of the cash register into an AC outlet.
3. Load the memory protection batteries.
4. Set the Mode Switch to REG.
(Figure 1)
2. To Select the Date Format and Monetary Mode
You can select the date format and Monetary mode after initialization depending on the requirements in your area.
Default date format is Day/Month/Year.
Default Monetary Mode is Add 2.
Example:
Change the date format to Month/
Day/Year, and change Monetary mode
to Add 0.
1. Set the Mode Switch to PGM.
2. Press the following keys.
P3 appears in mode
display
Program set code number
Select numbers from
lists A and B
(To end the setting)
Date Format Selections
A
Year/Month/Day ?
Month/Day/Year Z
Day/Month/Year X
Monetary Mode Selections
B
Add 0 (0. ) ?
Add 1 (0.0 ) Z
Add 2 (0.00 ) X
▲
Co
?ZXXo
Z?p
o
Note: To prevent to lose all of your settings and sales data, we reccomend you to install the
memory protection batteries.
◗ To load the memory protection batteries
1. Remove the printer cover.
2. Open the battery compartment cover.
3. Load 3 new UM-3, R6P (SUM-3) or LR6 (AM-3) type batteries into the
compartment. Be sure that the plus (+) and minus (–) ends of each battery are
facing in the directions indicated by the illustrations inside the battery compart-
ment (Figure 1).
4. Slide the memory protection battery compartment cover back into place.
5. Replace the printer paper and printer cover.
REPLACE MEMORY PROTECTION BATTERIES AT LEAST ONCE EVERY YEAR.
To Next Page
Loading...
Need help?
General
