Enabling/Disabling an Alarm
or the Hourly Time Signal
1.
Use (D) to display the item whose on/off
setting you want to change: alarm number
[1] to [4] or [SNZ], or the hourly time signal
([SIG]) screen.
Alarm or hourly time signal
2.
Press (A) to toggle the displayed alarm or
the hourly time signal between on and off.
Stopping an Alarm
Pressing any button while the beeper is
sounding stops it.
Determining an Alarm’s
On/Off Status
Turning on an alarm or the hourly time signal
causes the corresponding indicator to appear
on the display.
Snooze
Hourly time signal
Alarm
Stopwatch
The stopwatch can measure elapsed time up
to 23 hours, 59 minutes, 59 seconds (24
hours).
Getting ready
Enter the Stopwatch Mode.
l
Navigating Between Modes
Measuring Elapsed Time
1.
Use the operations below to measure
elapsed time.
●
Elapsed time is shown in 1/100-second
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
Hour, minute, second
After first hour
Minutes, seconds,
1/100 seconds
First hour
2.
Press (A) to reset the elapsed time to all
zeros.
Measuring a Split Time
1.
Use the operations below to measure
elapsed time.
●
Each press of (D) causes the elapsed
time up to that point (split time) to be
indicated.
D
A
A
D
Stop
Split release
Split
Start
●
Elapsed time is shown in 1/100-second
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
Hour, minute, second
After first hour
Minutes, seconds,
1/100 seconds
First hour
2.
Press (A) to reset the elapsed time to all
zeros.
Operation Guide 3459
12
To Next Page
Loading...
Need help?
General
