●
Setting the Time/Date
Use the procedure below to change the time
and date settings.
Important!
●
Configure the Home City setting before
changing the current time and date
settings.
l
Setting a Home City
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (E) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3. Use (D) to display the setting you want to
change.
●
Each press of (D) cycles through
settings in the sequence shown below.
Summer time
Home City
Minutes
Hours
Seconds
Day
Month
Ye a r
12/24-hour timekeeping
Changing Units
Illumination duration
Operation tone enable/disable
Power Saving
4. Configure the date and time settings.
●
While the seconds are flashing,
pressing (A) will reset them to 00. 1 is
added to the minutes when the current
seconds count is between 30 and 59
seconds.
●
For all the other settings, use (A) and (C)
to change the flashing setting.
Holding down (A) or (C) scrolls through
settings at high speed.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (E) twice to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3513
11
To Next Page
Loading...
Need help?
General
