●
Specifying the Illumination Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (E) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3. Press (D) 10 times.
[LIGHT] appears on the display with [1] or
[3] flashing.
4. Press (A) to select an illumination
duration.
[1]: 1.5-second illumination
[3]: 3-second illumination
5. Press (E) twice to complete the setting
operation.
Time Adjustment
Use the procedures in this section to adjust the
date and time settings.
Adjusting the Current Time
Setting
Use the procedures below to adjust the
current date and time settings, and to select a
Home City.
●
Setting a Home City
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area that observes summer time, you can also
enable or disable summer time.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (E) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3. Use (A) and (C) to change the Home City
setting.
●
Holding down (A) or (C) scrolls through
settings at high speed.
●
For details refer to the information
below.
l
City Table
4. Press (D).
5. Use (A) to change the summer time
setting.
●
[OFF]
The watch always indicates standard
time.
●
[ON]
The watch always indicates summer
time.
6. Press (E) twice to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 3513
10
To Next Page
Loading...
Need help?
General
