Changing to a Different
Phone Model
Q1
How do I connect my watch to a
different phone?
Delete the pairing information from your watch
and then pair it with the phone you want to
connect with.
l
If you purchase another phone
Auto Time Adjustment by
Bluetooth Connection (Time
Adjustment)
Q1
When does the watch adjust its time?
Your watch can connect with a paired phone to
adjust its time setting. Auto time adjustment is
performed at the times described below.
●
After your phone’s time zone or summer time
setting is changed
●
After 24 hours or more have passed since the
last time adjustment using Bluetooth
connection
●
After 24 hours or more have passed since city
swapping using OCEANUS Connected or
watch operation
●
After 24 hours or more have passed since the
last home city change or time adjustment using
watch operation
Q2
Auto time setting is not correct.
Is there a Bluetooth connection between the
watch and your phone?
To preserve battery power, the watch will
automatically terminate Bluetooth
connection with your phone temporarily if it
detects the connection has been unused for
approximately one hour. Auto Time
Adjustment is disabled while there is no
connection. To reconnect, press any watch
button or angle the watch towards your face.
Have 24 hours or more passed since the last
time adjustment using Bluetooth connection?
Time adjustment using Bluetooth connection
is performed once every 24 hours. Auto time
adjustment will be performed when 24 hours
or more have elapsed since the last time
adjustment operation.
Have 24 hours or more has passed since the
last manual time adjustment, city change, or
city swapping operation?
Auto time adjustment is not performed for 24
hours after a manual time adjustment, city
change, or city swapping operation. Auto
time adjustment will resume after 24 hours or
more have elapsed after either of the above
operations is performed.
Is the watch’s Airplane Mode enabled?
Connection with your phone is not possible
while the watch’s Airplane Mode is enabled.
To connect with your phone, disable the
Airplane Mode.
l
Using the Watch in a Medical Facility or
Aircraft
Have you left the watch unused for some
time?
Leaving the watch unused for some time will
cause it to enter a power saving state. In such
a state, the watch does not connect with your
phone via Bluetooth for auto time adjustment.
Exit the watch’s power saving state.
l
Recovering from Power Saving
Operation
Q3
Even if I hold down (B) for at least 0.5
seconds, the watch does not sync its
time setting with my phone.
Connection with your phone is not possible while
the watch’s Airplane Mode is enabled. To connect
with your phone, disable the Airplane Mode.
l
Using the Watch in a Medical Facility or
Aircraft
Q4
Time is not displayed correctly.
If your phone is unable to receive a signal because
you are outside its service range or for some other
reason, the watch may not be able to display the
correct time. If this happens, connect the phone
to its network and then adjust the time setting.
Q5
Time signal reception is not performed
while watch is connected with a phone.
The watch does not receive a time signal for time
correction while it is connected with a phone.
However, time signal auto receive is performed if
there has been no auto time adjustment based on
connection between the watch and phone for
more than one day.
Diving Function
Q1
I can’t enter the Dive Mode.
The watch will not enter the Dive Mode while
its charge is low or dead. Charge the watch
before using it for diving.
Q2
The watch enters the Calendar Mode
when it switches from dive time
measurement to surface interval
measurement.
If the watch charge becomes low while it is in
the Dive Mode, it will not be able to perform
surface interval measurement. Charge the
watch before using it for diving.
Tide Level
Q1
Tide level information is not
displayed when I enter the Tide
Graph Mode.
To check a tide level, use OCEANUS
Connected to specify a port.
Operation Guide 5624
24
To Next Page
Loading...
Need help?
General
