Casio Casiotone 1000P User Manual

Symptom
♦
Possible Cause
ir
Remedy
No sound comes
. The AC cord is not plugged in
1. Plug the AC cord properly.
out of the speaker
correctly.
even when press-
2. The Power Switch is OFF.
2. Turn the Power SwitchON.
ing the keyboard
3. The Main Volume Control Knob
3. Adjust, the volume level
keys.
is at its minimum.
to the desired level.
4. The Foot Volume Control Knob
4. Adjust the volume level
is at its minimum.
to the desired level.
5. Fleadphone is connected.
5. Disconnect the headphone.
The note continues
1. The MEMORY Button is on. 1. Press the MEMORY
to sound even Button off.
after fingers are 2. The TUNE Button is on. 2. Press the TUNE Button
removed from the
off.
keyboard keys.
The sound does
Since the permissible note range of Select other sounds or set the
not come out or
this instrument may be exceeded
pitch close to 442 Hz.
is not in tune in
when the pitch is set to the extreme
high note range.
upper limit, there may be these
cases. This especially applies to the
preset sound of "CHIME ” or the
programmed sounds which incor-
porate the FEET elements of
"CHIME ” .
The sound does not
When the TONE SET Button is on,
Press the TONE SET Button
change even when
only the sound of the lower two
off.
the Sound Selec-
octaves change.
tion Button is
pressed.
Noise is present
Noise
from electric appliances such
Use an AC outlet located as
as refrigerator or washing machine.
far as possible from motor-
ized appliances.
No sound comes
1. The Main Volume Control on the
1. Adjust the volume level to
out even an ex-
Casiotone is at its minimum.
the desired level.
ternal amplifier
2. The connection cord is bad.
2. Replace the connection
is connected.
cord.
.. ... . ........ 1
- 23 -

Casio Casiotone 1000P Specifications

General

Brand	Casio
Model	Casiotone 1000P
Category	Synthesizer
Language	English