MIDI:
POLY mode:
Send
channel
=
01
-16
Receive
channel
=
01-16
Program
change
=
ENABLE/DISABLE
MULTI CHANNEL
mode: Basic channel
=
01
-16
Voice
channel
=
01-16
(each
POLY
=
0-8,
each
LEVEL
=
01
-15)
Program
change
=
ENABLE/DISABLE
Communication
control: MIDI ON/OFF, system
exclusive
TONE
DATA
=
ENABLE/DISABLE
Other:
Solo ON/OFF
Rear panel:
Line out
terminal
(A/A
+
B, B), headphone terminal
(stereo),
sustain
terminal,
foot
volume
terminal, MIDI
terminal (IN, OUT, THRU),
protect
switch
(ON/OFF),
cartridge
slot, power supply terminal
Power supply: 100V, 120V, 220V,
240V AC
Memory back
up:
Built-in lithium battery
(life: approx. 5
years)
Power consumption: 30W
Dimensions: 1025(W) X 341 (D) X
1 27(H)mm
(403/8"(W) X 137i6"(D) X 5"(H))
Weight:
13kg
(28.7
lbs.)
Accessories:
AC power
cord, plug and cord set, dust
cover
"Designs and specifications
are
subject to
change without notice.
WARNING:
CHANGING THE VOLTAGE SELECTOR MAY REQUIRE THE
USE OF
A DIFFERENT
LINE
CORD
OR ATTACHMENT
PLUG, OR BOTH.
TO
REDUCE THE RISK
OF
FIRE
OR ELECTRIC
SHOCK, REFER
SERVICING
TO QUALIFIED SERVICE
PERSONNEL
GUIDELINES LAID DOWN BY
FCC RULES FOR
USE
OF
THE UNIT
IN THE
U.S.A.
(not
applicable
to other
areas).
This equipment
generates and
uses radio frequency energy
and if not installed
and
used
properly,
that is, in strict
accordance
with
the manufacturer's instructions,
may cause interference
to radio and
television
reception. It has been
type tested
and found
to
comply
with
the
limits
for a
Class
B
comput-
ing
device in accordance
with
the
specifications
in
Subpart
J
of Part 15 of
FCC
Rules,
which
are designed
to
provide
reasonable protection
against
such
interference
in
a
residential
installation.
However, there
is
no guarantee that interference will
not
occur in
a
particular installation.
If
this
equipment
does
cause
interference
to radio or television
reception, which can
be
determined
by
turning
the equipment off
and
on, the user
Is
encouraged
to try
to
correct
the
interference by one
or
more of the
following measures:
reorient
the
receiving
antenna
relocate the computer with
respect
to
the
receiver
move the computer away
from the receiver
plug the computer into
a
different
outlet
so
that
computer and receiver
are on
different branch circuits.
If necessary, the
user should consult
the
dealer or an
experienced
radio/television
technician for
addi-
tional
suggestions.
The
user
may
find
the following
booklet prepared
by the Federal
Communications
Commission helpful:
"How
to Identify and Resolve
Radio-TV Interference
Problems". This booklet
is
available from
the
US
Government Printing
Office,
Washington,
D.C.,
20402,
Stock No.
004-CKXWX)345-4.
-67-
k
To Next Page
Loading...
Need help?
General
