Connection
Connecting with a Phone
This section explains how to establish a
Bluetooth connection with a phone that is
paired with the watch.
●
If the watch is not paired with the phone you
want to connect with, refer to the information
below and pair them.
l
C
Pair the watch with a phone.
1. Move the phone close to (within one meter
of) the watch.
2.
X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
Important!
●
If you have problems establishing a
connection, it could mean that
EDIFICE Connected is not running on
the phone. On the phone’s Home
Screen, tap the “EDIFICE Connected”
icon. After the app starts up, hold down
the watch’s (B) button for at least two
seconds.
Note
●
The connection will be terminated if
you do not perform any operation on
the watch or phone for a fixed amount
of time.
To specify the connection limit time,
perform the following operation with
EDIFICE Connected: “Watch settings”
n
“Connection time”. Next, select a
setting of 3 minutes, 5 minutes, or 10
minutes.
Canceling a Connection with a
Phone
Pressing any button terminates the Bluetooth
connection and returns the second hand to its
normal operation.
30
30
DisconnectedConnected
Using the Watch in a Medical Facility
or Aircraft
You can use the procedure below to disable
auto time adjustment when you are in a
hospital, inside an aircraft, or in any other area
where use of a phone is prohibited or
restricted. To re-enable auto time adjustment,
perform the same operation again.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3.
Y
Perform the operation shown on the
phone screen to enable or disable auto
time adjustment.
Unpairing
Use the procedure below to delete pairing
information from EDIFICE Connected.
1.
X
If the watch is connected with a phone,
press any button to terminate the
connection.
30
30
DisconnectedConnected
2.
Y
Tap the “EDIFICE Connected” icon.
3.
Y
Perform the operation shown on the
phone screen to unpair.
If you want to disable connection between the
watch and a phone, perform the procedure
below to delete pairing information from the
watch.
1.
X
Pull out the crown to the second click.
This causes the second hand to move to
12 o’clock.
2.
X
Hold down (A) for at least five seconds.
When pairing information is deleted, the
second hand will to move from
e
to 12
o’clock.
3.
X
Push the crown back in.
If you purchase another phone
You need to perform the pairing operation
whenever you want to establish a Bluetooth
connection with a phone for the first time.
l
C
Pair the watch with a phone.
Watch Operation Guide 5666
14
To Next Page
Loading...
Need help?
General