Configuring Dual Time
Settings
Dual Time lets you keep track of the current
time in another time zone in addition your
current location time.
1. Pull out the crown to the first click.
This causes the second hand to move to
12 o’clock, and the function hand to move
to [DT].
2. Rotate the crown to change the Dual Time
setting.
●
You can set the Dual Time in 15-minute
increments.
30
Dual Time 24-hour
Dual Time hour and minute
＋
−
3. Push the crown back in.
Moving to Another Time Zone
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
●
Before Boarding
1. Configure the World Time (Dual Time)
setting to the current time at your
destination.
30
Destination time
Current time
l
Selecting a World Time City
2. Disable auto time adjustment.
l
Using the Watch in a Medical Facility or
Aircraft
●
After Arriving
1. Swap the origin time zone time with the
destination time zone time.
30
30
After swappingBefore swapping
Destination time
Destination time
l
Swapping Your World Time and Home
Time
2. Enable auto time adjustment.
l
Using the Watch in a Medical Facility or
Aircraft
3. Adjust the time setting.
l
Triggering Immediate Time Adjustment
Stopwatch
Pressing (A) in the Calendar Mode enters the
Stopwatch Mode and starts an elapsed time
measurement operation (Direct Start).
The stopwatch measures elapsed time in units
of one second up to 23 hours, 59 minutes, 59
seconds (24 hours).
Note
●
Direct Start is disabled while there is a
Bluetooth connection between the
watch and another device.
Measuring Elapsed Time
1. In the Calendar Mode, press (A).
l
Navigating Between Modes
This enters the Stopwatch Mode and
starts an elapsed time measurement
operation.
30
30
Seconds
Hours, minutes
Stopwatch ModeCalendar Mode
Hours (24-hour time)
2. Press (B) to reset the elapsed time to all
zeros.
●
To return to the Calendar Mode, reset
the stopwatch to all zeros and then
press (B).
Watch Operation Guide 5666
16
To Next Page
Loading...
Need help?
General