To Next Page

To Previous Page

— 13 —

3. How to use ADJ Tool when replacing MAIN PCB

Firmware is not installed in spare parts.

1 Enter the TEST mode.

1. Turn the power on while pressing both "MENU" and "DISP" buttons.

2. Press "RIGHT" button, "RIGHT" button and "MENU" button while the

program version is displayed.

3. Select "3.USB TCC TEST", and press "SET" button.

4. Select "1. USB TCC ON", and press "SET" button.

5. Turn the power OFF.

2 Connect the camera to the PC by the USB cable.

3 Boot "adj03ssaw".

4 Select the model name and click "Load FW  " Key.

• EX-Z30 앶앸 Kx877

• EX-Z40 앶앸 Kx871

5 Click "ADJ ALL READ", and display the data on the "adj03ssaw".

6 Save the data.

7 Replace the MAIN PCB.

8 Writing the Firmware.

Write the firmware into a spare part after replacing one.

NOTE: If a battery is inserted without the firmware, only LED blinks

green and the camera does not operate.

9 Perform the above 1 to 3.

0 Select the model name and click "Load FW  " Key.

• EX-Z30 앶앸 Kx877

• EX-Z40 앶앸 Kx871

A Open the file which is saved above, and display the data on the

"adj03ssaw".

B Click "WRITE" button of "ADJ ALL".

C After adjustment, change "1. USB TCC ON" to "2. USB TCC OFF".

Casio EX-Z30 User Manual

Questions and Answers: