75
Advanced Settings
NOTE
• Only Camera Stabilizer can be used during movie recording.
• ISO sensitivity, aperture, and shutter speed do not appear on the monitor screen
when you half-press the shutter button while “D Auto” or “S Image AS” is
selected. These values will appear briefly, however, in the preview image that is
displayed immediately after you shoot a snapshot.
• The ISO sensitivity setting (page 38) must be “AUTO” for “S Image AS” to work.
• Shooting while “D Auto” or “S Image AS” is selected can cause an image to
appear somewhat coarser than normal and can cause slight deterioration of image
resolution.
• Anti Shake may not be able to eliminate the effects of camera or subject movement
when movement is severe.
•“A Camera AS” may not work properly when the camera is mounted on a tripod.
Either turn off Anti Shake or select “S Image AS”.
Procedure
[r] (REC) * [MENU] * REC Tab * AF Area
For details, see the Control Panel procedure on page 36.
Procedure
[r] (REC) * [MENU] * REC Tab * AF Assist Light
Half-pressing the shutter button while this setting is selected causes
the front lamp to light, which provides illumination for focusing in
areas where lighting is dim. Leaving this function turned off is
recommended when shoot portraits from short distances, etc.
IMPORTANT!
• Never look directly into the front lamp while it is lit.
Specifying the Auto Focus Area (AF Area)
Using the Auto Focus Assist Light (AF Assist Light)
Front lamp
C
To Next Page
Loading...
Need help?
General
