Casio PB-100 User Manual

■ Power Supply and Battery Replacement
This unit uses two lithium batteries (CH2032) for a power supply.
If the contrast is weak even when the eontrast control is adjusted for maximum contrast
(refer to paye 11), this means that the batteries are worn out. Therefore, please replace
the batteries at the earliest opportunity using the following procedure.
Furthermore, even though the unit is functioning normally, be sure to replace the
b a t t e r i e s e v e r y 2 y e a r s . S c r e w s
I 1 ^ ,
• H o w t o R e p l a c e t h e B a t t e r i e s ^ i
(1) After turning the power switch off, loosen the two
screws on the rear panel and remove the rear panel.
ALL RESET button
(After replacing the batteries,
press with a pointed object.)
(2) While pressing (g), slide the battery compartment lid (i "
in the direction of the arrow and remove it.
--7-TT~r—-(A;"
(3) Remove Ifie old batteries.
(This will be easier if you tap the unit lightly
with the battery compartment facing down.)
(4) Using a dry cloth, wipe off the new batteries and
insert them with the <3side facing up.
(5) While pressing the batteries down with the battery
compartment lid, slide it closed.
(6) Replace the rear panel and tighten the screws ana
after turning the power switch on, press the ALL
RESET button.
Be sure to replace both batteries. . , -3
Never throw the old batteries into a fire. This is very dangerous as
might explode.
Be sure to position the0and ©terminals correctly.
-4-

Casio PB-100 Specifications

General

Brand	Casio
Model	PB-100
Category	Desktop
Language	English