— 18 —
Meaning
Data specified in search operation
does not exist in memory.
No more room in memory for stor-
age of data.
Attempt to set an alarm that is al-
ready used for another entry.
Attempt to set an alarm for a time
or data that is already passed.
Error during data communica-
tions.
The reset procedure has started.
The reset procedure is in
progress.
Data corrupted by strong impact,
electrostatic charge, etc.
The main batteries are getting
weak.
Action
Change specification or cancel
search.
Delete unnecessary data items
from memory.
Set a different alarm time or
change the existing alarm time.
Set a different alarm time.
Cancel the operation and try
again.
See page 6.
See page 7.
See page 18.
Replace main batteries imme-
diately (page 9).
Message
NOT FOUND!
PRESS ESC TO QUIT.
MEMORY FULL,
PRESS ANY KEY.
ALARM TIME COINCIDENT!
ALARM TIME ALREADY
PASSED!
DATA COMM. ERROR,
PRESS ANY KEY!
DATA SYNC. ERROR,
PRESS ANY KEY!
ARE YOU USING A NEW
UNIT FOR THE FIRST TIME
(Y/N)?
CLEAR MEMORY AND SET UP
THE UNIT FOR OPERATION?
YES (OK)/NO (ESC)
DATA ERROR! CHECK
YOUR USER’S GUIDE FOR
PROCEDURE!
MAIN BATTERIES WEAK!
REPLACE THEM! UNIT WILL
NOT TURN ON AGAIN!
5. ERROR MESSAGES
Data Error Message
The data error message appears whenever the Digital Diary’s internal check discovers a problem with
data stored in memory.
Appearance of the data error message indicates that you must perform the all-reset procedure to
correct the problem. Start out with the procedure under “To start the all-reset operation” on page 6,
and continue with the procedure under “When to press Y for “Yes” on page 6”.
Important!
• Even though you are not using the unit for the first time, you must press Y (for “Yes”) when the unit
asks “ARE YOU USING A NEW UNIT FOR THE FIRST TIME (Y/N)?” in order to reset the unit
after a data error occurs.
If you still have trouble after trying the RESET operation, you may have a hardware problem.
■ Message Table
To Next Page
Loading...
Need help?
General
