CEM DT-9935 User Manual

6.Operation Instructions
Push key function allowed to be active will be marked as "
When LCR power on,all of the LCD segments will be ON for 2
seconds. Then the default initialization process will be started.
The default mode is AUTOLCR smart mode and the default test
frequency is 1 kHz.When the PWR_KEY is pushed during power
-on mode,the meter will enter power-off mode.The LCD will show
the "OFF" state before the whole system enters the power off
status.
In order to extend the battery life, except of using external
power supply, APO feature will be helpful. It can be enabled or
disabled APO function by press the APO button and the LCD will
show whether the function is enable or not. When all function
keypads do not be pushed or impedance range switching detected
within 5 minutes, the system will launch the alarm buzzer beep
at three times before the auto power-off status. During the period
of alarm, the meter will be kept in operation by pushing any
function key again. If any key is not in operation further, the
system power will be off.
If the function keypad available is pushed,the buzzer output
beeps once.If the function keypad not available is pushed,the
buzzer beeps twice.
◆"
•
•
•
Power ON/OFF
Auto power off
Buzzer
Keypads
AUTOLCR
L
C
ACR
DCR
FUNC
HOLD
Dqθ S/P
BKLIT
SORT
REL%
FREQ
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
◆
9
Dual Display LCR Meter Instruction Manual

CEM DT-9935 Specifications

General

Brand	CEM
Model	DT-9935
Category	Measuring Instruments
Language	English