11
Helpline No: UK 0151 649 1500 / IRE 189 094 6244
GB
Fault Cause Remedy
The motor does not start Power failure
Safety switch on the debris box not
locked in position
Check the mains lead, plug and
fuse.
Ensure debris box is in position
and locked.
Material is not drawn in by the
shredder
The shredding blade is running in
reverse.
Material blockage in the filling
funnel
The shredding blade is jammed
Change the direction of rotation.
Change the direction of rotation
and pull the material out of the
funnel. Feed in thick branches
again so that the blade does not
immediately engage again in the
notches it previously cut.
Change the direction of rotation.
The blade will now release the
jammed material.
The material is not shredded
properly
The counter blade is not set
correctly.
Adjust the counter blade. See
section 6.8 on how to do so.
10. Troubleshooting
To Next Page
Loading...
Need help?
General