To
shift
from
4LO
to
4HI: Stop your vehicle. Shift your transmission into
N
(Neutral) or depress your clutch pedal. Press and release the 4HI switch. You
must wait for the green 4HI indicator light to stop flashing and go solid green
before shifting your transmission into gear or releasing the clutch pedal.
If the 4HI switch is pressed wh’en your vehicle is in gear and/or moving, the
green 4H1 indicator light will flash for
30
seconds but not complete the shift
unless the vehicle is below
3
mph and the transmission is in
N
(Neutral) or
the clutch pedal depressed.
On automatic transmission equipped vehicles:
If
your transfer case does not
shift into- 4HI, your transmission indicator switch may require adjustment. With
your transmission in
N
(Neutral), press and release the 4HI switch. While the
green 4HI indicator light
is
flashing, shift your transmission into
P
(Park). Wait
until the 4HI indicator light goes solid green before shifting your transmission
into gear. This will get you into 4HI, but you should take your vehicle in for
service
so
normal operation can be restored.
To
shift
from
4LO
to
two-wh’eel drive,
“lW0
WHEEL”:
You must shift from
4LO to 4HI before shifting back into two-wheel drive.
Windows
To open your manual windows, turn the hand crank on each door to raise or
lower your side door windows.
If
you have the optional power windows, the co’ntrols are on each of the side
doors.
The driver’s door has a switch for the passenger windows as well. Your
power windows
will
only work when the ignition has been turned to
Run.
231
To Next Page
Loading...
Need help?
General
