1-15
Suburban/Yukon XL: To put the seat back in, place
the front of the seat on the load floor, facing the front
of the vehicle. While holding the rear of the seat up, use
the wheels on the front of the seat to roll it towards the
seat hooks in the floor. When the latches are engaged in
the hooks, let the seat drop into place. Lift up on the
carrying handle to make sure the seat is locked in place.
Raise the seatback into the upright position. Push and
pull on the seat to make sure it is locked into place.
The seatback cannot be raised to the upright position
unless the seat is secured to the floor.
CAUTION:
A seat that isn’t locked into place properly can
move around in a collision or sudden stop. People
in the vehicle could be injured. Be sure to lock
the seat into place properly when installing it.
Safety Belts: They’re for Everyone
This part of the manual tells you how to use safety belts
properly. It also tells you some things you should not do
with safety belts.
And it explains the air bag system.
CAUTION:
Don’t let anyone ride where he or she can’t wear
a safety belt properly. If you are in a crash and
you’re not wearing a safety belt, your injuries
can be much worse. You can hit things inside the
vehicle or be ejected from it. You can be seriously
injured or killed. In the same crash, you might
not be if you are buckled up. Always fasten your
safety belt, and check that your passengers’ belts
are fastened properly too.
To Next Page
Loading...
Need help?
General
