Shifting
Out
of
NEUTRAL
To
shift out of NEUTRAL:
1.
Set the parking brake and apply the regular brake
2. Shift the transmission to NEUTRAL
(N)
and turn the
3.
Press the button for the desired transfer case shift
4.
After the transfer case has shifted out of NEUTRAL
pedal.
ignition to
RUN
with the engine
off.
position (All-Wheel Drive or
4LO).
the red light will go out.
5.
YOU
may start the engine and shift the transmission
to the desired position.
Parking Brake
To
set the parking brake, hold the regular brake pedal
down with your right foot. Push down the parking
brake pedal with your left foot.
A chime will activate and the warning light will flash
when the parking brake is applied and the vehicle
is moving at least
3
mph
(5
km/h) for at least
three seconds.
To
release the parking brake, hold the regular brake
pedal down. Pull the bottom edge of the lever, located
above the parking brake pedal, with the parking
brake symbol, to release the parking brake.
If the ignition is on when the parking brake is released,
the brake system warning light will go
off.
Notice:
Driving with the parking brake on can
cause your rear brakes to overheat. You may have
to replace them, and you could also damage
other parts
of
your vehicle.
If
you are towing a trailer and are parking on any hill,
see Towing a Trailer on page
4-59.
2-35
To Next Page
Loading...
Need help?
General
