Chevrolet Blazer Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
15165663) - 2022 - CRC - 6/2/21
Vehicle Care 325
{
Warning
Do not bleach or dye seat belt webbing.
It may severely weaken the webbing. In
a crash, they might not be able to
provide adequate protection. Clean and
rinse seat belt webbing only with mild
soap and lukewarm water. Allow the
webbing to dry.
Floor Mats
{
Warning
If a floor mat is the wrong size or is not
properly installed, it can interfere with
the pedals. Interference with the pedals
can cause unintended acceleration and/or
increased stopping distance which can
cause a crash and injury. Make sure the
floor mat does not interfere with the
pedals.
Use the following guidelines for proper floor
mat use:
.
The original equipment floor mats are
designed for your vehicle. If the floor
mats need to be replaced, it is
recommended that GM-certified floor
mats are purchased. Non-GM floor mats
may not fit properly and may interfere
with the pedals. Always check that the
floor mats do not interfere with the
pedals.
.
Do not use a floor mat if the vehicle is
not equipped with a floor mat retainer on
the driver side floor.
.
Use the floor mat with the correct side
up. Do not turn it over.
.
Do not place anything on top of the
driver side floor mat.
.
Use only a single floor mat on the
driver side.
.
Do not place one floor mat on top of
another.
Button Retainer
Some vehicles have floor mats with a
button-type retainer.
Removing and Replacing the Floor Mat
1. Pull up on the rear of the mat to unlock
and remove.
2. Reinstall the floor mat by lining up the
floor mat opening over the carpet
retainer and snapping into position.
3. Make sure the floor mat is properly
secured. Verify the floor mat does not
interfere with the pedals.