12
SETTING CRUISE CONTROL
1. Press the On/Off button. The Cruise
Control symbol will illuminate in white on
the instrument cluster.
2. When traveling at the desired speed,
press the SET– button to set the speed.
The symbol will illuminate in green on the
instrument cluster.
ADJUSTING CRUISE CONTROL
RES+ Resume/Accelerate
Press the RES+ button to resume a set speed. When the system is active, press the
button to increase speed.
SET– Set/Coast
When the system is active, press the SET– button to decrease speed.
Cancel
Press to cancel the Cruise Control without erasing the set speed from memory. Pressing
the brake pedal also will cancel the Cruise Control.
ADAPTIVE CRUISE CONTROL
F
The system enhances regular cruise control to maintain a following gap — the time
between your vehicle and a vehicle detected directly ahead — by accelerating or braking
automatically while you continue to steer.
Press the
Following Gap button to select a gap setting of Far, Medium or Near.
This is also the Forward Collision Alert
F
setting.
Press and hold the Cancel button to switch between regular Cruise Control
and Adaptive Cruise Control.
See Driving and Operating in your Owner’s Manual.
CRUISE CONTROL
F
Optional equipment
INTELLIBEAM LIGHTING SYSTEM
F
The IntelliBeam system automatically turns the high-beam headlamps on/off based on
traffic conditions when the system is activated, indicated by a green indicator on the
instrument cluster. A blue indicator appears when the high-beam headlamps are on.
To enable the system, press the IntelliBeam button on the turn signal lever with
the exterior lamps control in the AUTO or Headlamps position.
Note: IntelliBeam activates the high-beam headlamps only when driving over 25 mph.
See Lighting in your Owner’s Manual.
To Next Page
Loading...
Need help?
General
