Chicco LiteWay Plus Instructions For Use

24
25
10.Pressthesidebuttonstoreturnthelegresttoitsoriginalposi-
tion(diag.12).
2.6 REAR BRAKES
Therearwheelsarettedwithabrakingsystemwhichallowsyou
toapplythebrakestotherearwheelgroups.
11.Toapplythebrakes,pressoneofthetwopedalsontherear
wheelsinthecentreoftherearwheelgroupdownwards,(diag.
13),pushthestrollerforwardstocheckthatthebrakeisON.
WARNING:afterapplyingthebrakepedals,checkthatthebrakes
arelockedinplaceonbothrearwheels.
12.Toreleasethebrakes,pushoneofthetwopedalsonthecen-
tralrearwheelgroupupwards(diag.14).
2.7 FRONT SWIVEL WHEELS
Thestrollerhasswivel/xedfrontwheels.Itisrecommendedto
usethexedwheelsonparticularlyunevenground.Itisrecom-
mendedtousetheswivelwheelsonnormalroadsurfacesasit
makesiteasiertohandle.
13.Tounlocktheswivelwheels,raisethefrontlever,asseenin
diagram15.Tolocktheswivelwheels,useyourfoottolowerthe
lever.Whateverthecurrentpositionofthewheel,itwilllockina
straightposition.
WARNING:Bothwheelsmustbeblockedorunlockedatthesametime.
2.8 SUMMER/WINTER HOOD
Thestrollercomeswithahood.
14.Fitthehoodinplacefasteningtheplasticclipstotherelative
hooks,(diag.16)andjointhetwovelcrostrapstothesidetubes
(diag.17).
WARNING:Thehoodmustbettedcorrectlyonbothsidesofthe
stroller.Checkthatitissecurelyfastened.
15.Openthehood(diag.18A)andpressthetwosidesnap-bars
downtolockitinplace(diag.18B).
WARNING:alwaysreleasethesetwosnap-barsbeforetryingto
closethehood.
16.Youcanalsounziptherearaptoensureincreasedventilation
foryourbabyinsummer(diag.18C).
2.9 CLOSING THE STROLLER
WARNING:whenperformingthisoperation,makesurethatyour
childandallotherchildrenareatasafedistance.Ensurethatdur-
ingtheseoperationsthemovingpartsofthestrollerdonotcome
intocontactwithyourchild.Beforeclosingthestroller,checkthat
thebasketisemptyandneitherthecarseat(optional)northe
bumperbar(optional)areattached.
17.Ifopen,closethehoodbyraisingthetwosidesnap-bars(diag.
19A)andpullthefrontsectionuptowardsthehandles(diag.19B).
18.Toclosethestroller,pulltherearcrossbarupwards(diag.20A)
anduseyourfootto releasethe pedalonthe rightsideofthe
stroller(diag.20B)
19.Nowpushthehandlesforwardandtheclosureprocedureis
complete(diag.21).
20.Whenitisclosed,thehookonthesideautomaticallylocks
thestrollerinaclosedposition(diag.22)topreventitfromac-
cidentallyopening.
2.10 REMOVABLE LINING
Thestrollerhasacompletelyremovablelining.
21.Toremovethelining,startbyraisingthelegrest(diag.23)to
removeitslining(diag.23A).Nowremovetheclasps(diag.23B),
openthetwopress-studsthatsecurethefabrictieslocatedunder
theseat(diag.23C);openthetwovelcrostrapsalongthebackrest
tubes(diag.24)andremovethelining,checkingthatthelapbelt
doesn’tgetcaught.
22.Openthepress-studsonthefrontstrollertubes(diag.25A),
and release the two plastic inserts located on the side stroller
tubes(diag.25B).Nowremovetheliningpullingitupandover
thebackrest.
2.11 TO REPLACE THE LINING ON THE FRAME
Followtheinstructionsbelowtoreplacethelining.
23.Positionthefabricliningonthestrollerbackrest.
24.Threadthelapbeltsthroughtherelativeslots(diag.26).
25.Fastenthetwoplasticinsertslocatedonthesidestrollertubes
(diag.27B)andfastenthetwofabrictiestothereartubesusing
thetwopress-studs(diag.27B).
26.Fastenthetwovelcrostrapsalongthebackresttubes(diag.
27C),ttheliningoverthelegrest(diag.28)andclosethetwo
press-studs that secure the fabric ties located under the seat
(diag.29B);nowtthebucklesinplace(diag.29A).
3 ACCESSORY LIST
WARNING:Theaccessoriesdescribedbelowarenotnecessarily
availableonsomeversionsoftheproduct.
1Storagebasket
1full-coverrainhood
1FootMuff–Legcover
1Bumperbar(optional)
3.1 STORAGE BASKET
Thestrollercanbettedwithapracticalcarry-allbasket.
27.Fastentheloopstothedesignatedxtures(diag.30)tofasten
thebasketinplace.
3.2 FULL-COVER RAIN HOOD
Araincovercanalsobettedontothestroller.
28.Toassemblethefull-coverrainhood,threadthetiesaround
the stroller tubes in the positions indicated in diagram  31.
Whenyouhavenishedusingtheraincover,allowittodryinthe
openair(ifitiswet)beforefoldingitaway.
WARNING: pay particular attention when using the full-cover
rainhood.
WARNING:theraincovercannotbeusedonastrollerwhichhas
nohoodorsun-hood asitcouldsuffocatethechild.Whenthe
raincoveristtedonthestroller,neverleaveitexposedtodirect
sunlightwiththe child inside, asthetemperaturewillrisecon-
siderably.
WARNING:onlyusetheraincoversuppliedwiththeproductkit.
3.3 FOOT MUFF / LEG COVER
Afootmuff,idealforcoldclimates,canbeassembledonsome
versionsofthisstroller,andcanbeturnedintoalegcover.
FOOT MUFF
29.Fastenthefootmuffin placeusingthepress-studsas seen
indiagram32.
30.Thetopendofthefootmuffisttedwithtwovelcrostraps
usedtofastenittotherearofthebackrest(diag.33).
31.Thefootmuffalsohasslotstothreadthesafetyharnessstraps
throughwheninuse(diag.34).
WARNING:alwaysthreadtheharnessstrapsthroughthedesig-
natedslotswhenusingthefootmuff.
LEG COVER
32.Thefootmuffcaneasilybeturnedintoalegcoverbyunzip-
pingit(diag.35)andremovingtheeecelining.
33.Totthelegcover,fastentheclipsinplacebythreadingtheties
aroundthestrollertubesinthepositionsindicatedindiagram36.
3.4 BUMPER BAR
Thebumperbarisanoptionalaccessorythatcanbeusedonall
versionsoftheLitewayPlusStroller.
MAINTENANCE AND CLEANING
Thebumperbarhasnoremovablelining.
34.Cleanallthefabricpartswithadampspongeandneutralde-
tergent.
Useasoftclothtocleantheplasticpartsonaregularbasis.Al-
waysdryanymetalpartsthatcomeintocontactwithwaterto
preventtheformationofrust.
ASSEMBLY
35.Usethefastenerleverstoattachthebumperbartotheframe
(diag.37).Makesurethatthebumperbaristtedcorrectlyon
thestrollerbeforeplacingthechildinside.Followtheassembly
instructionstoguaranteecorrectuseofthebar(Diag.38)When
assembledcorrectly,thearrowstampedonbothfastenerlevers
mustbepointingupwards.
REMOVAL
36.Releasethefastenerleverstoremovethebumperbar,asseen
indiagram39.

Chicco LiteWay Plus Specifications

General

Brand	Chicco
Model	LiteWay Plus
Category	Stroller
Language	English