EasyManuals Logo
Home>Cisco>Network Hardware>1000 Series

Cisco 1000 Series User Manual

Cisco 1000 Series
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Step 3 Disconnect all port cables connected to the router. Ensure that you do not work on the router with cables still attached to
the router in the event of lightning or surges.
Step 4 Installer to disconnect all cables connected to the system.
Step 5 Place the chassis on a flat surface.
Step 6 Remove the 14x cover screws on the two sides of the router cover. See figure.
Step 7 Slide the cover from bezel side to I/O side until it stops.
Step 8 Pull the cover vertically to disengage from the chassis.
Replace the Cover
To replace the cover, do these steps:
The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed. Statement 1077.
Warning
Replace the 14 screws on either side of the cover.1 and 2
Install and Upgrade Internal Modules and Field Replaceable Units
3
Install and Upgrade Internal Modules and Field Replaceable Units
Replace the Cover

Other manuals for Cisco 1000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 1000 Series and is the answer not in the manual?

Cisco 1000 Series Specifications

General IconGeneral
BrandCisco
Model1000 Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals