Removing and Replacing the Internal PoE Daughter Card
Use the following procedure to remove and replace the Internal PoE daughter card:
Step 1
Read the Safety Warnings and disconnect the power supply before you remove or replace the module.
Step 2
Open the chassis, locate the PoE daughter card assembly.
Step 3
Remove the three M3 (48-0530-01) screws.
Step 4
Pull the PoE daughter card out of the connector. If replacing the card, insert the new PoE daughter card and tighten the
screws to a torque of 5 in-lb.
Step 5
Place the removed card in an anti-static bag to protect it from ESD damage.
To upgrade the PoE daughter card, follow the steps mentioned in the Installing the Internal PoE Daughter Card
section.
Note
Removing and Replacing the USB Flash Token Memory Stick
The Cisco 1100 Series ISRs contain port for a 1 GB flash token memory stick to store configurations or Cisco
IOS XE consolidated packages.
Only Cisco USB Flash memory modules are supported by Cisco routers.Note
Do not remove a USB Flash memory module when issuing some file access command or a read/write
operation to the Flash memory module when it is processing. The router might reload or the USB Flash
memory module can be damaged. You can check to see if the USB activity LED on the router front panel
is flashing, prior to the removal of the USB device
Caution
To remove and then replace a USB flash token memory stick from the router, follow these steps:
Step 1
Pull the memory stick from the USB port.
Step 2
To replace a Cisco USB Flash memory stick, simply insert the module into the USB port. The Flash memory module
can be inserted in only one way, and can be inserted or removed regardless of whether the router is powered up or not.
What to Do Next
This completes the USB Flash memory installation procedure.
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
5
Installing and Upgrading Internal Modules and FRUs
Removing and Replacing the USB Flash Token Memory Stick
To Next Page
Loading...
Need help?
General
