Cisco 1100 Series Installing And Upgrading

AC Power Supplies
Overview of the AC Power Supply
Power supply of the Cisco 1100 Series ISRs is an external AC to DC power adapter. The external power
adapter DC power connector plugs in to the router 4-pin power connector, to power the unit.
Figure 4: Power Supply Unit
Power Cable1
Installing and Removing SFP Modules
This section describes how to install optional small-form-factor pluggable (SFP) modules in the router to
provide optical Gigabit Ethernet connectivity.
The SFP module installs into a slot on the router rear panel. When selected in Cisco IOS software, it is assigned
port gigabitethernet 0/0/0. The default is the built-in RJ-45 1000Base-T connector, which is enabled on this
port.
Only SFP modules certified by Cisco are supported on the routers.
Table 1: SFPs Supported on the Router
DescriptionMinimum
IOS-XE Version
Cisco Model
Number
1000BASE-EX
SFP transceiver
module, SMF,
1310nm, DOM
3.15GLC-EX-SMD
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
6
Installing and Upgrading Internal Modules and FRUs
AC Power Supplies

Cisco 1100 Series Specifications

General

Brand	Cisco
Model	1100 Series
Category	Network Router
Language	English