Cisco 1841 User Manual

21
Cisco 1841 Integrated Services Router with AIM-VPN/BPII-Plus and Cisco 2801 Integrated Services Router with AIM-VPN/EPII-Plus
OL-8719-01
Secure Operation of the Cisco 1841 or Cisco 2801 router
Secure Operation of the Cisco 1841 or Cisco 2801 router
The Cisco 1841 and Cisco 2801 routers meet all the Level 2 requirements for FIPS 140-2. Follow the
setting instructions provided below to place the module in FIPS-approved mode. Operating this router
without maintaining the following settings will remove the module from the FIPS approved mode of
operation.
Initial Setup
• The Crypto Officer must apply tamper evidence labels as described in the “Physical Security”
section on page 10 of this document.
• The Crypto Officer must disable IOS Password Recovery by executing the following commands:
configure terminal
no service password-recovery
end
show version
Note Once Password Recovery is disabled, administrative access to the module without the
password will not be possible.
System Initialization and Configuration
• The Crypto Officer must perform the initial configuration. IOS version 12.3(11)T03, Advanced
Security build (advsecurity) is the only allowable image; no other image should be loaded.
• The value of the boot field must be 0x0102. This setting disables break from the console to the ROM
monitor and automatically boots the IOS image. From the “configure terminal” command line, the
Crypto Officer enters the following syntax:
config-register 0x0102
• The Crypto Officer must create the “enable” password for the Crypto Officer role. The password
must be at least 8 characters to include at least one number and one letter and is entered when the
Crypto Officer first engages the “enable” command. The Crypto Officer enters the following syntax
at the “#” prompt:
enable secret [PASSWORD]
• The Crypto Officer must always assign passwords (of at least 8 characters) to users. Identification
and authentication on the console port is required for Users. From the “configure terminal”
command line, the Crypto Officer enters the following syntax:
line con 0
password [PASSWORD]
login local

Cisco 1841 Specifications

General

Flash memory	32 MB
Internal memory	128 MB
Product color	Black, Blue, Stainless steel
Rack capacity	1U
LED indicators	Yes
Storage temperature (T-T)	-25 - 65 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 85 %
Cabling technology	10/100Base-T(X)
Networking standards	-
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
USB ports quantity	1
Ethernet LAN (RJ-45) ports	2
Firewall security	Cisco IOS
Security algorithms	128-bit AES, 192-bit AES, 256-bit AES, 3DES, DES
Dual-band	No

Weight and Dimensions

Depth	274 mm
Width	343 mm
Height	47.5 mm
Weight	2800 g