3-15
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24567-01
Chapter
Configuring Startup Network Settings
2. The screen displays the Cisco Systems, Inc., logo screen.
3. These messages appear as the phone starts up.
–
Phone not registered
4. The home screen displays:
–
Current date and time
–
Primary directory number
–
Additional directory numbers and speed dial numbers, if configured (Only on Cisco Unified IP
Phone 6961)
–
Softkeys
If the phone successfully passes through these stages, it has started up properly. If the phone does not
start up properly, see the “Resolving Startup Problems” section on page 9-1.
Configuring Startup Network Settings
If you are not using DHCP in your network, you must configure these network settings on the
Cisco Unified IP Phone after installing the phone on the network:
• IP address
• IP subnet information
• IPv6 addresses
• TFTP server IP address
• You also may configure the domain name and the DNS server settings, if necessary.
Collect this information and see the instructions in Chapter 4, “Configuring Settings on the Cisco
Unified IP Phone.”
Configuring Security on the Cisco Unified IP Phone
The security features protect against several threats, including threats to the identity of the phone and to
data. These features establish and maintain secure communication streams between the phone and the
Cisco Unified Communications Manager server, and digitally sign files before they are delivered.
For more information about the security features, see the “Understanding Security Features for Cisco
Unified IP Phones” section on page 1-14. Also, refer to Cisco Unified Communications Manager
Security Guide.
Table 3-2 LED Diagnostic Status
Hardware Test MWI Hold Mute Speaker
Power is Ready OnOnOnOn
Flash is Accessible — On On On
RAM Test Successful — — On On
Ethernet Test Successful———On
To Next Page
Loading...
Need help?
General
