DescriptionIdentifier
Icon shows wrong for share line testbedCSCun47170
phone couldn't switch to another line if 2 remote hold call bubble thereCSCun47290
line key flashing too long time for broadcast huntgroupCSCun47366
call bubble not show for huntgroup numberCSCun47509
phone EW alerting is abnormal after making an incoming callCSCun50430
78xx Can not use the default gateway as SRSTCSCun50485
not support the 32-bit SRTCPCSCun51311
Phone will send out a number automatically after offhookCSCun55006
Resolved Caveats
The following table lists severity 1, 2, and 3 defects that are resolved for the Cisco IP Phones that use Firmware
Release 10.1(1)SR1.
For more information about an individual defect, you can access the online record for the defect by clicking
the Identifier or going to the URL that is shown. You must be a registered Cisco.com user to access this online
information.
Because defect status continually changes, the table reflects a snapshot of the defects that were open at the
time this report was compiled. For an updated view of open defects, access Bug Toolkit as described in Access
Cisco Bug Search, on page 5.
Table 3: Resolved Caveats for Firmware Release 10.1(1)SR1
HeadlineIdentifier
7861 can't indicate missed call correctlyCSCuj70181
7861 can't display prompt of missed call and new VM fluentlyCSCuj70644
Idle URL screen can't display if 7861 phone has missed call notificationCSCuj82934
JPN+KOR+CHS: 78xx: Multi-Byte Service name is corrupted
The fix for this defect will be available with the next device
pack.
Note
CSCuj90768
No alert info returns via cli command when power saving alert pop upCSCul09519
78XX webpage shows ITL file not installed when it is installedCSCul14019
making a new call when hoot&holler is active may lead to phone's crashCSCul65321
Cisco IP Phone 7821, 7841, and 7861 Release Notes for Firmware Release 10.1(1)SR1
7
Cisco IP Phone 7821, 7841, and 7861 Release Notes for Firmware Release 10.1(1)SR1
Resolved Caveats
To Next Page
Loading...
Need help?
General
