Cisco 7945G User Manual

Cisco Unified IP Phone 7965G and 7945G Phone Guide for Cisco Unified Communications Manager 7.0 53
Using a Wireless Headset
Refer to the wireless headset documentation for information about using the wireless headset’s remote
features. Also, check with your system administrator to be sure your phone is enabled to use a wireless
headset with the wireless headset remote hookswitch control feature.
Using Wideband with your Headset
If you use a headset that supports wideband, you might experience improved audio sensitivity if you
enable the wideband setting on your phone (this setting is disabled by default). To access the setting,
choose
> User Preferences > Audio Preferences > Wideband Headset.
If the Wideband Headset setting shows as dimmed, then this setting is not user controllable.
Check with your system administrator to be sure your phone system is configured to use wideband. If
the system is not configured for wideband, you may not detect any additional audio sensitivity even
when using a wideband headset. To learn more about your headset, refer to the headset documentation
or ask your system administrator for assistance.
Using a Speakerphone
Many of the actions you can take to dial a number or answer a call will automatically trigger
speakerphone mode, assuming that the handset is in its cradle and
is not lit.
If you want to... Then...
Toggle speakerphone mode on
or off
Press .
Switch to a handset Lift the handset.
Adjust the volume level for a
call
Press during a call or after invoking a dial tone.
Press Save to preserve the volume level for future calls.

Cisco 7945G Specifications

General

Brand	Cisco
Model	7945G
Category	IP Phone
Language	English