Where:
sd= speed dial
cp= call pickup
You can also enable busy lamp field only with call pickup or speed dial. Enter the string in the following
format:
fnc=blf+cp;sub=xxxx@$PROXY;usr=yyyy@$PROXY
fnc=blf+sd;sub=xxxx@$PROXY;usr=yyyy@$PROXY
You can also configure the parameter in the configuration file (cfg.xml) by entering a string in the following
format:
<Unit_1_Key_2_ ua="na">fnc=blf;ext=3252@$PROXY;nme=BLF_3252</Unit_1_Key_2_>
Step 5 Click Submit All Changes.
Enable the User to Configure Features on Key Expansion Module Line Keys
You can enable the user to configure features on the line keys of the key expansion module. The user can then
add any of the configured features to the dedicated line keys. For the supported features, see Configurable
Features on Line Keys.
Before you begin
• Access the phone administration web page. See Access the Phone Web Interface.
• Ensure that the line keys of the key expansion module are not in the Inert mode.
Procedure
Step 1 Select Voice > Att Console.
Step 2 In the General section, configure the Customizable PLK Options parameter with the codes of your desired
features defined in Configurable Features on Line Keys.
Example: You configure this parameter with blf;shortcut;dnd;. The user can call up the feature list with
a long-press on a key expansion module line key. The feature list looks like:
1 None
2 BLF presence
4 Menu shortcut
3 Do not disturb
The user can then select a feature or a menu shortcut to add to the line key.
You can also configure this parameter in the configuration file (cfg.xml) with a string in this format:
<Customizable_PLK_Options ua="na">blf;shortcut;dnd;</Customizable_PLK_Options>
Cisco IP Phone Accessories
29
Cisco IP Phone Accessories
Enable the User to Configure Features on Key Expansion Module Line Keys
To Next Page
Loading...
Need help?
General
