Cisco ASR 1000 Series Replacing

Step 5 Remove the internal drive cover:
a) Using a # 2 Phillips screwdriver or a flat head screwdriver, loosen the screw fasteners on the cover.
b) Slide the cover off as shown in xref Figure 14-2.
c) Lift the cover up from the board.
Step 6 Inspect the existing cables and replace them only if they are damaged. If you do not need to replace them, leave the
connection to the Cisco ASR 1000 Series Route Processor 1 in place and only remove the connection to the internal hard
drive.
Step 7 Carefully disconnect the cables at the rear of the hard drive. These cables are tie-wrapped in to prevent them from
disconnecting from the Cisco ASR 1000 Series RP1 itself. If the cables are not damaged, leave the cables connected to
the Cisco ASR 1000 Series RP1 with the tie wrap in place. Remove the old hard drive.
The following figure shows the cables still connected because they do not have to be replaced.
Figure 3: Cisco ASR1000-RP1 Module With Internal Hard Drive Removed
Step 8 If the cables are damaged:
a) Remove the tie wrap around the cables.
b) Disconnect the cables from both the Cisco ASR 1000 Series Route Processor 1 connector and the internal hard drive
connector as shown in the following figure.
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
7
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing the Cisco ASR1000-RP1 Internal Hard Drive

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English