EasyManuals Logo
Home>Cisco>Network Router>ASR 1002-X

Cisco ASR 1002-X Overview And Installation

Cisco ASR 1002-X
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Step 3 Using the bottom rack mount ear hole, insert the screw through cable management bracket and into the chassis rack mount
(see Figure 15: Chassis Rack Mount Bracket Ear Holes for the Cable Management Brackets, on page 25).
What to do next
This completes the procedure for installing the cable management brackets on the chassis.
Attaching a Chassis Ground Connection
Connecting the Cisco ASR 1002-X chassis to ground is required for all DC-powered installations and
AC-powered installation where compliance with Telcordia grounding requirements is necessary.
The dual-lug chassis ground stud must be installed and all the cards and filler plates must be fully inserted,
screwed in, and earthed to prevent a potential hazard in a telecom line.
Caution
Have the recommended tools and supplies available before you begin this procedure.
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available. Statement 1024
Warning
Before you connect power or turn on power to your chassis, you must provide an adequate chassis ground
(earth) connection for the chassis. The chassis ground lug (two) and the respective screws (four) are provided
in the accessory kit that shipped with your Cisco ASR 1002-X Router.
The grounding wire is always the first to be installed or connected and the last to be removed or disconnected.
Caution
The following tools, equipment, and supplies are necessary to connect the system ground to the chassis:
P
hillips screwdriver
Dual-lug chassis ground component (two) and respective screws (four) (shipped with the accessory kit)
Grounding wire
The following image shows the location of the ground lug on the side of Cisco ASR 1002-X Router.
Cisco ASR 1002-X Router Overview and Installation
26
Cisco ASR 1002-X Router Overview and Installation
Attaching a Chassis Ground Connection

Other manuals for Cisco ASR 1002-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 1002-X and is the answer not in the manual?

Cisco ASR 1002-X Specifications

General IconGeneral
BrandCisco
ModelASR 1002-X
CategoryNetwork Router
LanguageEnglish

Related product manuals