Cisco ASR 1002-X Overview And Installation

Step 3 After you establish normal router operation, disconnect the terminal, if required.
Management Ethernet Port Cable Connection
To comply with Class A emission requirements, a shielded Ethernet cable must be used for the connection.
Caution
On the front panel of the router, the Management Ethernet port is labeled MGMT ETHERNET. To use the
Management Ethernet interface on the router, perform the following steps:
SUMMARY STEPS
1. Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port.
2. Insert the other end of the RJ-45 cable to your management device or network.
DETAILED STEPS
Step 1 Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port.
Step 2 Insert the other end of the RJ-45 cable to your management device or network.
What to do next
A connection will not be established when setting up an out-of-band connection or modem connection in the
auxiliary port and the console port.
Note
Cisco ASR 1002-X Router Power Supplies
This section describes the Cisco ASR 1002-X Router power supplies and how to connect them:
Read the safety warnings before you begin.
The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed. Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last. Statement
1046
Warning
Cisco ASR 1002-X Router Overview and Installation
30
Cisco ASR 1002-X Router Overview and Installation
Management Ethernet Port Cable Connection

Cisco ASR 1002-X Specifications

General

Brand	Cisco
Model	ASR 1002-X
Category	Network Router
Language	English