Step 3 Remove the standby RP2 card. When RP2 is removed, an alarm is generated indicating that the redundancy
is lost. Follow the procedure explained in the topic Removing and Replacing Cards from the Chassis, on page
25.
Step 4 Insert RP3 in slot 1 and allow RP3 to bootup.
Step 5 Verify both the RPs are in IOS XR RUN state using the show platform command.
Example:
Router#show platform
Node Type State Config state
---------------------------------------------------------------------------
0/RP0/CPU0 A99-RP2-SE(Active) IOS XR RUN NSHUT
0/RP1/CPU0 A99-RP3-SE(Standby) IOS XR RUN NSHUT
0/FT0 ASR-9922-FAN-V2 OPERATIONAL NSHUT
0/FT1 ASR-9922-FAN-V2 OPERATIONAL NSHUT
0/FT2 ASR-9922-FAN-V2 OPERATIONAL NSHUT
0/FT3 ASR-9922-FAN-V2 OPERATIONAL NSHUT
0/1/CPU0 A9K-8X100GE-TR IOS XR RUN NSHUT
0/FC0 A99-SFC2 OPERATIONAL NSHUT
0/FC1 A99-SFC2 OPERATIONAL NSHUT
0/FC2 A99-SFC2 OPERATIONAL NSHUT
0/FC3 A99-SFC2 OPERATIONAL NSHUT
0/FC4 A99-SFC2 OPERATIONAL NSHUT
0/FC5 A99-SFC2 OPERATIONAL NSHUT
0/FC6 A99-SFC2 OPERATIONAL NSHUT
0/PT1 A9K-AC-PEM-V2 OPERATIONAL NSHUT
0/PT2 A9K-AC-PEM-V2 OPERATIONAL NSHUT
0/PT3 A9K-AC-PEM-V2 OPERATIONAL NSHUT
Step 6 Verify RP2 in slot 0 and RP3 in slot 1 reach full synchronization (NSR-ready state) and status of ALL the
groups is in Ready state. Use show redundancy command to verify the same.
Step 7 Manually copy Embedded Event Manager (EEM) scripts from RP2 to RP3 disks if applicable.
The EEM scripts are files located on RP’s hard disk. These files are not automatically synced
between Active and Standby RPs.
Note
Step 8 From active RP, verify both RPs have synchronized the SNMP engine ID and SNMP ifindex-table between
each other:
Example:
#more disk0:snmp/ifindex-table loc 0/rp0/cpu0
#more disk0:snmp/ifindex-table loc 0/rp1/cpu0
#more disk0:snmp/snmp_persist loc 0/rp0/cpu0
#more disk0:snmp/snmp_persist loc 0/rp1/cpu0
Step 9 Perform redundancy switchover from active RP2 to standby RP3. This results in RP3 (slot 1) becoming active
RP and RP2 (slot 0) becoming standby RP.
Example:
Router# redundancy switchover
Step 10 Verify that both the RPs are in IOS XR RUN state using the show platform command
Replacing Cisco ASR 9000 Series Router Components
31
Replacing Cisco ASR 9000 Series Router Components
Migrating from RP2 to RP3 Card
To Next Page
Loading...
Need help?
General
