Example:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2 Press Return to enter user EXEC mode. The following prompt appears:
Router>
Step 3 From user EXEC mode, enter the enable command as shown in the following example:
Router > enable
Step 4 At the password prompt, enter your system password. If an enable password has not been set on your system, this step
may be skipped. The following example shows entry of the password called enablepass :
Password: enablepass
Step 5 When your enable password is accepted, the privileged EXEC mode prompt appears: #
Step 6 You now have access to the CLI in privileged EXEC mode and you can enter the necessary commands to complete your
desired tasks. To exit the console session, enter the quit command as shown in the following example:
Example:
Router#quit
Configuring Global Parameters
When you first start the setup program, you must configure the global parameters. These parameters are used
for controlling system-wide settings. Perform the following steps to enter the global parameters:
Step 1 Connect a console terminal to the console port, and then boot the router.
This is only an example of the output display; prompts may vary.
Note
When you see this information, you have successfully booted your router:
Example:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Cisco ASR 903 Initial Configuration
6
Cisco ASR 903 Initial Configuration
Configuring Global Parameters
To Next Page
Loading...
Need help?
General
