DescriptionItem
Press this button to create a problem report using the Problem Report
Tool.
This is not a power button. When you press this button, a
problem report is generated and uploaded to a server for the
system administrator.
Note
Problem Report Tool (PRT) Button
Flashing amber: The PRT is preparing the data for the problem report.
Fast Flashing amber: The PRT is sending the problem report log to
the PRT server.
Solid green for five seconds, then off: The PRT report was sent
successfully.
Flashing red: The PRT report failed. Press the PRT button to turn the
LED off. Once it is off, another press triggers a new PRT report.
Problem Report Tool (PRT) LED
ATA 191 Back Panel
The back panel of your ATA has several ports used to connect your device and to power it. The back panel
also has the reset button for resetting the device to the factory settings.
Figure 2: ATA 191 Back Panel
The following table describes the ports that are located on the back panel of your ATA.
Table 2: ATA 191 Back Panel Ports
DescriptionPort or Button
To restart the ATA, use a paper clip or similar object to press this button
briefly.
To restore the factory default settings, press and hold for 10 seconds.
RESET
Use an RJ-11 phone cable to connect an analog phone or fax machine.PHONE 1
Use an RJ-11 phone cable to connect a second analog phone or fax
machine.
PHONE 2
Use an Ethernet cable to connect to the network.NETWORK
Use the provided power adapter to connect to a power source.DC 5V POWER
Get Started with Your New ATA
3
Get Started with Your New ATA
ATA 191 Back Panel
To Next Page
Loading...
Need help?
General
