Cisco C1121-4PLTEP User Manual

To maintain compliance, the minimum separation distance from the antenna to general bystander is 20 cm
(8,7 inches) or more.
CANADA
This Class [*] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [*] est conforme à la norme NMB-003 du Canada
Radio (Wi Fi)
This product complies with RSS-247 of the Industry Canada Rules. Its operation is subject to the following
two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause an undesired
operation.
Ce dispositif est conforme à la norme RSS-247 d'Industrie Canada applicable aux appareils radio exempts de
licence. Son fonctionnement est sujet aux deux conditions suivantes:
• le dispositif ne doit pas produire de brouillage préjudiciable
• ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite system.
For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the bands 5250-5350
MHz and 5470-5725 MHz must be such that the equipment still complies with the e.i.r.p. limit.
For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850
MHz must be such that the equipment still complies with the e.i.r.p. limits as appropriate.
For systems that are capable of operating outdoors or with antennas mounted outdoors (where applicable
antenna type(s), antenna models(s), and worst-case tilt angle(s)) are necessaryto remain compliant with the
e.i.r.p, therefore, the elevation mask requirement set forth in section 6.2.2.3 should be clearly indicated.
Radio (Wi Fi)
This product complies with the RSS of the Industry Canada rules.
Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm (7.87 in.) between the radiator
and yourself.
C1109-4PLTE2P = 27 cm
Note
Déclaration D'exposition Aux Radiations
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement
non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm (7.87 in.) de distance
entre la source de rayonnement et votre corps.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
88
Supplier Declaration of Conformity

Cisco C1121-4PLTEP Specifications

General

DSL WAN	No
Ethernet WAN	Yes
Wi-Fi band	Dual-band (2.4 GHz / 5 GHz)
Wi-Fi standards	802.11a, 802.11b, 802.11g, Wi-Fi 5 (802.11ac)
Top Wi-Fi standard	Wi-Fi 5 (802.11ac)
WLAN data transfer rate (max)	1000 Mbit/s
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11i, IEEE 802.11r, IEEE 802.1x
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
3G	-
USB version	3.2 Gen 1 (3.1 Gen 1)
Combo SFP ports quantity	1
Ethernet LAN (RJ-45) ports	5
Power over Ethernet (PoE) ports quantity	2
Security algorithms	3DES, 802.1x RADIUS, AES, DES
Flash memory	4096 MB
Internal memory type	DRAM
Product color	Silver
Output voltage	12 V
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	66 W
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 65 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 85 %
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	226 mm
Width	322 mm
Height	41.9 mm
Weight	1560 g