• When equipment installed in a rack (particularly in an enclosed rack) fails, try operating the equipment
by itself, if possible. Power off other equipment in the rack (and in adjacent racks) to allow the router
under test a maximum of cooling air and clean power.
Power Guidelines and Requirements
Check the power at your site to ensure that you are receiving power that is free of spikes and noise. Install a
power conditioner if necessary.
Power
Guidelines
and
Requirements
lists
power
requirements
for
the
Cisco
<platform
name>.
T
able
5:
Power
Requirements
for
<platform
name>
Output RatedInput RatedPower Source
12 VDC, 5.5A100-240V, 2A66W AC Power Adapter
(PWR-66W-AC-V2)
12V, 4.6A, -53.5V 1.12A100-240VAC, 2A, 50-60 Hz115W AC Power Adapter
(PWR-115W-AC)
12V , 2.5A100-240 VAC, 1A30W AC Power Adapter
(PWR-30W-AC)
12V 5.5A, -53.5 1.5A100-240 VAC, 2A150W AC Power Adapter
(PWR-150W-AC)
12 VDC, 5.5A24 V DC Nominal (19.7V DC to
30 V DC input range)
66W DC Power Adapter
(PWR-66W-I-DC)
Network Cabling Specifications
The following sections describe the cables and thee specifications required to install Cisco 1100 Series ISRs:
Console Port Connections
The C111x has both EIA/TIA-232 asynchronous (RJ-45) and USB 5-pin micro Type B, 2.0 compliant serial
console ports. The console ports do not have any hardware flow control. Shielded USB cables with properly
terminated shields are recommended.
EIA/TIA-232
Depending on the cable and the adapter used, this port appears as a DTE or DCE device at the end of the
cable. Only one port can be used at the same time.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
25
Prepare for Router Installation
Power Guidelines and Requirements
To Next Page
Loading...
Need help?
General
