Cisco C220 M3 User Manual

Figure 5: Network Interfaces Setup Diagram
In Threat Grid Appliance (v2.7.2 and later), there is also the enable_clean_interface option, which is disabled
by default. This option (after applying configuration and rebooting) enables access to the administrative
interface on port 8443 of the assigned clean IP.
Note
Firewall Rules
This section provides suggested firewall rules.
Implementing a restrictive outgoing policy on the Dirty interface for ports 22 and 19791 requires tracking
updates over time and spending more time maintaining the firewall. See the required destinations in the
configuration sections.
Note
Using IPv4LL address space (168.254.0.16) for the Dirty interface is NOT supported.
Note
Server Setup
5
Server Setup
Firewall Rules

Cisco C220 M3 Specifications

General

Maximum Processors	2
Memory Slots	24 DIMM slots
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Remote Management	Cisco Integrated Management Controller (CIMC)
Processor	Intel Xeon E5-2600 series
Memory	Up to 768 GB
Network Interfaces	2 x 1GbE ports
Expansion Slots	3 x PCIe 3.0 slots
Power Supply	650W hot-plug redundant
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Form Factor	1U rack server