Cisco C220 M3 User Manual

NoteActionPortProtocolDestinationSource
Allow connectivity to Threat
Grid support.
Allow19791TCPInternetDirty
Interface
Connect with third-party
detection and enrichment
services.
Allow443TCPCisco UmbrellaDirty
Interface
Connect with third-party
detection and enrichment
services.
Allow443TCPVirusTotalDirty
Interface
Connect with third-party
detection and enrichment
services.
Allow443TCPTitaniumCloudDirty
Interface
Power On and Boot Up Appliance
Once you have connected the server peripherals, network interfaces, and power cables, turn on the appliance
and wait for it to boot up. The Cisco screen is briefly displayed.
Figure 6: Cisco Screen During Bootup
If you want to configure this interface, press F8 after the memory check is completed and follow the instructions
in CIMC Configuration.
Note
Server Setup
8
Server Setup
Power On and Boot Up Appliance

Cisco C220 M3 Specifications

General

Maximum Processors	2
Memory Slots	24 DIMM slots
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Remote Management	Cisco Integrated Management Controller (CIMC)
Processor	Intel Xeon E5-2600 series
Memory	Up to 768 GB
Network Interfaces	2 x 1GbE ports
Expansion Slots	3 x PCIe 3.0 slots
Power Supply	650W hot-plug redundant
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Form Factor	1U rack server